Schreiber-chillers 1001ACsf User Manual

TABLE OF CONTENTS Model ……………………………………………………………………………………………... 1 Caution ……………………………………………………………………………………………. 2 Starting Check List ……………

REFRIGERATION SYSTEM The refrigeration system is a medium temperature system with a range from 350 F to 700 F. This is the most efficient range. If

FAN MOTORS AIR COOLED SPECIFICATIONS: H.P. 1/2 – 2 each. VOLTAGE - 460/200/230 PHASE 3 HZ-50-60 RPM 1140 OVERLOAD - Automatic, Internal FRAME

2.1. General 2.1.1. Locate pump as near liquid source aspossible (below level of liquid for automatic

2.3.2. Place unit in position on wedges located atfour points (two below approximate center

6.1.1. Single-phase motor: Non-reversible. 6.1.2. Three-phase motor: Interchange any

1001AC 18

WARNING Overcharging a refrigeration or air conditioning system can be dangerous. **** If a system refrigerant overcharge is sufficient to immerse

SERVICE BULLETIN HERMETIC COMPRESSOR ELECTRICAL TERMINAL VENTING CAN BE DANGEROUS ****** When the insulating material, which supports a hermetic com

Hermetic compressors can be properly serviced without unnecessarily removing the terminal PROTECTIVE COVER by adhering to the following service proced

9. If once again a ground is indicated, proceed to properly replace the compressor, as it has failed and cannot be repaired. 10. It is important t

WATER CHILLER STARTING CHECKLIST PROPER VOLTAGE Check the voltage on the chiller to see that it matches your power supply. CRANK CA

Again, we want to stress that it is essential that WHENEVER ELECTRIC POWER is applied to the motor-compressor, the terminal PROTECTIVE COVER must be p

MAINTENANCE INFORMATION 1. There are no lubrication points on the chiller. All motors have permanent lubrication in the bearings. 2. The water t

TROUBLE SHOOTING - PART I SYMPTOM DIAGNOSIS REMEDY Compressor won't run Check Power supply Electrical circuit Check Line load

TROUBLE SHOOTING - PART II REFRIGERATION SYSTEM INTERNAL PRESSURE USING REFRIGERANT R-22 * High Pressure Switch : Manual Reset - Cut out at 425 P.

CHILLER PARTS IDENTIFICATION 27 1001AC

PARTS LIST 1001AC/WC - 460/3 or 230/3 If this unit has special feature(s) installed, see appendix for part number(s). Part Number Description 460/3

Schreiber Limited Warranty S chreiber warrants the product described herein against defective material or workmanship for one year from

CONT. WATER CHILLER STARTING CHECKLIST ELECTRIC – POWER A good test to make sure power is off to the unit is to turn on the water pump swi

SETTING SOLID STATE CONTROL This unit has a solid-state control that controls the temperature on the refrigeration system. After the unit is wired

Chilled Water Distribution Piping The chilled water distribution piping is an important factor in the performance of the water chiller. Proper piping

INSTALLATION INSTRUCTION Air or Water Cooled Chillers 1. When the chiller is received, check for any shipping damage. If any is found, a freight cla

7. Fan motors - Air-cooled only, fan motors will run when refrigeration system is calling for cooling. You can lower the sound level of the fan motors

SPECIAL INSTRUCTIONS WATER PUMP The water pump is controlled by the manual switch for off and on operations. The motor on this pump has a built-i

CHILLED WATER CIRCUIT The chilled water is pumped from the chiller's water tank to the discharge outlet of the chiller. Then from the discharge