Schreiber-chillers SETTING SOLID STATE CONTROL User Manual download pdf

SETTING SOLID STATE CONTROL

This unit has solid-state controls that regulates the temperature of the

refrigeration system. After the unit is wired to the proper voltage the temperature

and high temperature alarm can be set.

Setting the Temperature

Press and hold the black button #7 as you turn the set point screw. The

temperature shown on the discharge temperature display will indicate the

temperature set point as you turn the set point screw.

Setting the High Temperature Alarm

To set the high temperature alarm, press and hold the black button #8 as you

turn the set point screw. The discharge temperature display will indicate the set

temperature for the high temperature alarm as you turn the set point screws. We

suggest you keep a 5-degree differential between the temperature set points and

the alarm point.

Turning off the Alarm

Press button #9 to turn the alarm off.

CHECKING TEMPERATURE SET POINTS

To check the temperature set points, just press #7 for the compressor set point

and #8 for the alarm set point.

CAUTION

This panel is designed for indoor use only. Approved outdoor panel covers are

available from the factory. Please contact the parts department at Schreiber

Engineering.

LOW LEVEL WARNING LIGHT

There is a float switch mounted in the reservoir tank. When the water in this reservoi

reaches a low level, the float switch closes causing the light on the enclosure cover to

come on. In order to correct this condition, you must fill the reservoir to its proper level.

Part Number: E126 & P155

1 2

SETTING SOLID STATE CONTROL This unit has solid-state controls that regulates the temperature of the refrigeration system. After the unit is wired t

Page 2

No comments

Schreiber-chillers SETTING SOLID STATE CONTROL User Manual